I am looking to apply under NOC CODE 2232 (http://noc.esdc.gc.ca/English/noc/ProfileQuickSearch.aspx?val=2&val1=2232&ver=16&val65=mechanical) for my foreign work experience and here is a draft of my letter. Would this be sufficient to apply under this code?
To whom it may concern,
I, xxxx, hereby write this letter to attest that xxxx, holder of passport number: xxxx worked for our company, xxx - CNPJ: xxxx, starting from May 19th, 2015 to June 30th, 2016. During this period, he held the position of Junior Mechanical Designer in our office located at rua xxxx, xxxx - xxx, xxxx - xxxx, xxxx, Brazil.
His duties were as follows:
- Develop 2D/3D CAD designs and drawings;
- Run simulations and experiments to attest for the structural resistance of new equipment;
- Assist in the technical analysis of mechanical components aiming for performance optimization and cost reduction;
- Assist in the cost analysis generation through the input of components to the enterprise resource planning (ERP) system, based on the equipment’s bill of materials (BOM);
- Specify materials, machine elements and components for mechanical equipment;
- Participate in the design of tooling for new equipment;
- Support the implementation of new designs into the manufacturing chain.
His workload was 30 hours a week for which he was paid R$ xxxxx monthly, equivalent to approximately R$ xxxx / Year.
If you require any further clarifications, please contact me at email address or telephone number.
To whom it may concern,
I, xxxx, hereby write this letter to attest that xxxx, holder of passport number: xxxx worked for our company, xxx - CNPJ: xxxx, starting from May 19th, 2015 to June 30th, 2016. During this period, he held the position of Junior Mechanical Designer in our office located at rua xxxx, xxxx - xxx, xxxx - xxxx, xxxx, Brazil.
His duties were as follows:
- Develop 2D/3D CAD designs and drawings;
- Run simulations and experiments to attest for the structural resistance of new equipment;
- Assist in the technical analysis of mechanical components aiming for performance optimization and cost reduction;
- Assist in the cost analysis generation through the input of components to the enterprise resource planning (ERP) system, based on the equipment’s bill of materials (BOM);
- Specify materials, machine elements and components for mechanical equipment;
- Participate in the design of tooling for new equipment;
- Support the implementation of new designs into the manufacturing chain.
His workload was 30 hours a week for which he was paid R$ xxxxx monthly, equivalent to approximately R$ xxxx / Year.
If you require any further clarifications, please contact me at email address or telephone number.